Specification; Certification - Source Technologies STm.58b User Manual

5. Pritner Specification

5-1 Specification

Printing Method
Printing Speed
Resolution
Character
Character per line
Character set
Barcode
Emulation
Driver
Sensor
Paper paper type
width
thickness
External Diameter
Internal Diameter
Reliability TPH
Battery
Communications
MSR (Optional) Card Standard
Track
Magnet Head Life
Battery Charger input
output
Battery Battery type
output
Charging time
Size W X D X H(mm)
W X D X H"
Weight
Temperature operation
storage
Humidity operation
18
Direct Thermal
80mm/sec
203 DPI X 203 DPI
Font A (12X24), Font B (9X17)
Font A : 32 columns , Font B : 42 columns
ALPHA NUMERIC Charactor, Extension grapic
EAN-8, EAN-13, Code39, ITF, UPC-A,
Coda bar, Code93, Code128
ESC/POS
Window CE 4.2 & 5.0, Window Mobile 5.0
Paper End Sensor , Cover open Sensor
Thermal Paper
58mm
65㎕
Max. Φ40mm
12.5mm +/-0.5mm
50km
Continuous printing: 29min
Standby: 10hours 20min
Printing length: 130m
Serial(RS-232C), USB, Bluetooth Class2
ISO7811/2, JIS
1Track, 2Track, 3Track, JIS-II
300,000 Passes(minimum)
AC100~240V, 50/60 Hz
8.4V , 800~1400mA
Li-ion
7.4V, 1130mAh
2hours
96 X 136 X 58
3.7 X 5.3 X 2.2
0.4kg
-10 ~ 50℃
-20 ~ 60℃
35 ~ 95%

6.Certification

FCC Information
This device complies with part 15 of the FCC Results. Operation is
subject to the following two conditions:
(1) This Device may not cause harmful interface, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for CLASS
B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instuctions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try correct the interference by one or more of the
following measures:
1.1. Reorient or relocate the receiving antenna.
1.2. Increase the separation between the equipment and receiver.
1.3. Connect the equipment into an outlet on a circuit different from
that to which receiver is connected.
1.4. Consult the dealer or experienced radio/TV technician for help.
WARNING
Changes or modifications not expressly approved by the manufacturer could void
the user's authority to operate the equipment.
19