Viewing Target Mapping (Linux And Vmware Esx) - Emulex ProLiant BL620c - G7 Server User Manual

Target Mapping Field Definitions
Current Settings Area
• Active Bind Type - WWPN, WWNN, or a destination identifier (D_ID).
• Automapping - The current state of SCSI device automapping: enabled (default) or disabled.
• Auto-Persistent Binding - The current state of the Auto-Persistent binding service. (Not available
on VMware ESX servers being managed through the CIM interface.)
Current Mappings Area
• This table lists current mapping information for the selected adapter port.
Persistent Binding Configuration Area
• This table lists persistent binding information for the selected adapter port. (Not available on
VMware ESX servers being managed through the CIM interface.)
Display Mode Radio Buttons
• Show WWPN, Show WWNN or Show D_ID options enable you to choose how to display
information in the Persistent Binding Configuration table.
Target Mapping Buttons
• Refresh - Click to refresh the Target Mapping tab.
• Change Settings - Click to enable or disable automapping, choose a bind type and enable or
disable LUN mapping and unmasking. (Not available on VMware ESX servers being managed
through the CIM interface.)
• Add Binding - Click to add a persistent binding.
• Bind New Target - Click to add a target that does not appear in the Persistent Binding table.
• Remove - Click to remove the selected binding.
• Remove All Bindings - Click to remove all persistent bindings that are displayed.

Viewing Target Mapping (Linux and VMware ESX)

Use this tab to view target mapping. The Target Mapping tab is read-only.
Note: Persistent binding is not supported by the Linux 2.6 kernel, the Emulex 8.2 version of the driver for Linux
or by VMware ESX Server.
Note: Not all information is displayed on systems using CIM provider v1.2.1 on ESX 3i and
CIM provider v2.0 on ESX 4i.
To view target mapping:
1. Select Host or Fabric view.
2. Select the adapter port in the discovery-tree whose target mapping information you want to view.
3. Select the Target Mapping tab.
Target Mapping Field Definitions
Current Settings Area
• Active Bind Type - N/A
• Automapping - N/A
The OneCommand Utility User Manual Page 75