Emulex ProLiant BL620c - G7 Server User Manual page 172

Table 4. Parameters Not Available (Continued)
Command Attribute
Invalid Rx Frame
CRC Cnt
Link Transition
Count
Active RPI Count
Active XRI Count
Rx Port Busy
Count
Rx Fabric Busy
Count
Primary
Sequence Time-
out
Elastic Buffer
Overrun
Arbitration Time-
out
GetVPD
GetxcvrData
LoadList
a
SetDriverParam
WWN Manage-
ment
a. Temporary driver parameters are supported in ESX 3i U2, U3, and U4.
Driver Parameters that are set temporarily and globally (using the "G" and "T" flags) must be read
using the "GetDriverParams" hbacmd command to view the current value of the parameter. The
"GetDriverParamsGlobal" hbacmd command shows only permanent driver parameter values. If
temporary, global values have been set for one or more driver parameters, the "SaveConfig"
hbacmd command must be run with the "N" flag to force the driver parameter values for the spec-
ified adapter to be saved. Inaccurate values may be saved if the "G" flag is used for this com-
mand.
Note: For the LoadList command, the attribute Program ID is displayed as "Not Available",
on ESX 3i U4 via CIM Provider v 2.0.9.x.
The OneCommand Utility User Manual
Not Available on Not Available on
ESX 3i U2 & U3 ESX 4 via CIM
via CIM Provider Provider v 2.0.22.1
v 1.2.1.x or later
X
X
X
X
X
X
X
X
X
X
Not Available on
ESX 3i U4 via CIM
Provider v 2.0.9.x
Page 165