Emulex ProLiant BL620c - G7 Server User Manual page 176

Parameters:
WWPN1 - World Wide Port Name of the adapter whose status you want to check.
WWPN2 - Must be "ff:ff:ff:ff:ff:ff:ff:ff" for switch or actual WWPN for target.
InitiateAuth
Supported by: Windows, Solaris SFS and Linux
Syntax: hbacmd InitiateAuth <WWPN1> <WWPN2>
Description: Initiates the authentication configuration on the adapter.
Parameters:
WWPN1 - World Wide Port Name of the adapter whose authentication configuration you want to initiate.
WWPN2 - Must be "ff:ff:ff:ff:ff:ff:ff:ff" for switch or actual WWPN for target.
SetAuthConfig
Supported by: Windows, Solaris SFS and Linux
Syntax: hbacmd SetAuthConfig <WWPN1> <WWPN2> <PasswordType> <Password> <Parameter>
<Value>
Description: Sets the authentication configuration for the adapter.
Parameters:
WWPN1 - World Wide Port Name of the adapter whose authentication configuration you want to set.
WWPN2 - Must be "ff:ff:ff:ff:ff:ff:ff:ff" for switch or actual WWPN for target.
PasswordType - 1 = ASCII, 2 = Hex (binary), 3 = Password not yet defined.
Password - Current password value.
Parameter - Parameters include Mode, Timeout, Bi-directional, Hash-priority, DH-priority, Re-
authentication, and Re-authentication-interval.
Value - Parameter-specific value: Mode = <disabled, enabled, passive>, Timeout = time in seconds, Bi-
directional = <disabled, enabled>, Hash-priority = <md5, sha1> (md5 = first md5, then sha1; sha1 = first
sha1, then md5), DH-priority = <1,2,3,4,5>, any combination up to 5 digits, Re-authentication =
<disabled, enabled>, Re-authentication-interval = < 0, 10 - 3600>.
SetPassword
Supported by: Windows, Solaris SFS and Linux
Syntax: hbacmd SetPassword <WWPN1> <WWPN2> <Flag> <Cpt> <Cpw> <Npt> <Npw>
Description: Sets the password for the adapter.
Parameters:
WWPN1 - World Wide Port Name of the adapter for which you want to set a password.
WWPN2 - Must be "ff:ff:ff:ff:ff:ff:ff:ff" for switch or actual WWPN for target.
Flag - 1 = Local (password used by adapter when adapter authenticates to the switch), 2 = Remote
(password used by adapter when switch authenticates to the adapter).
Cpt - Current password type is 1 = ASCII or 2 = Hex (binary), 3 = Password not yet defined.
Cpw - Current password value
Npt - New password type is 1 = ASCII or 2 = Hex (binary).
The OneCommand Utility User Manual Page 169