assembly
MOUNTING
MOTOR
1. Find four 5/16"-18x
1" carriage bolts, flat washers,lock-
washersand nuts supplied with base.
2, Insert bolts through holes marked "X"
from behind
motor mount bracket.
3. Attach motor..,
place a flat washer and a Iockwasher
on each holt . . . screw on nuts but DON'T TIGHTEN
them.
4. Loosen the two BELT GUARD
SUPPORT SCREWS.
5. Loosen the two MOTOR BASE CLAMP SCREWS and
rotate
the motor so that the ventilation holes are
facing downward ...
tighten the screws.
6. Tighten the BELT GUARD SUPPORT SCREWS.
MOTOR MOUNT
BRACKET
-[
:
c:_
L--J_ _-_c:_
BELT GUARD
SUPPORT SCREWS _,_
VENTILATION
HOLES
FACING
DOWNWARD
MOTOR BASE
CLAMP SC
(BOTH ENDS)
12