Installing Table - Craftsman 113.24201 Owner's Manual

TABLE TRUNNION
INSTALLING TABLE
Remove the protective oil that is applied to the table.
Use any ordinary household type grease and spot remover.
CAUTION: Never use gasoline, naptha or similar highly
volatile solvents.
Apply a coat of automobile wax to the table.
\
\
NION PiN
TABLE LOCK BOLT
1. Place the table on the band saw so that the two trunnion
pins and the table lock bolt go through the slot in the
trunnion.
2. Find the 1-I/8" dia. flat washer, a sleeve 11/16" long,
the trunnion lock nut and the table lock handle from
among the loose parts,
3, Hold the head of the table lock bolt inside the band saw
with your left hand and put the 1-1/8" dia. flat washer,
the sleeve, and the handle on the bolt.
4. Screw the nut on the bolt and tighten it with the handle
while the table is in a horizontal position.
_NUT
lllJ,;/
TABLE LOCK BOLT TABLE LOCK HANDLE