Advertisement
DRILL-DRIVER
Chuck
Motor
Gear Train
Switch
No Load Speed
Clutch
Maximum Torque
PRODUCT
SPECIFICATIONS:
315.267380
1/2 in. Keyless
DC Motor 14.4 Volt
Two Speed
Variable Speed
0-350/min.
(Low)
0-1200/rain.
(High)
24 Positions
320 in.lb.
CHARGER
Input
Charging Voltage
Charge Rate
BATTERY
PACK
Item No. 9 11040
(981399-001)
120 V, 60 Hz, AC only
9.6 - 24 Volt
t Hour
Item 1315107
OR Item No, _911033
(981403-001
)
KNOW YOUR
DRILL-DRIVER
See Figure 1.
Before attempting to use your drill-driver, familiarize
yourself with all operating features and safety
requirements.
,_,
WARNING:
Carefully read through this entire
operator's manual before using your new drill-driver.
Pay close attention to the Rules For Safe Operation,
Warnings and Cautions. If you use your drill-driver
properly and only for what it is intended, you will enjoy
years of safe, reliable service.
,_
WARNING:
Do not allow familiarity with your drill-
driver to make you careless. Remember that a care-
less fraction of a second is sufficient to inflictsevere
injury.
KEYLESS
CHUCK
Your drill-driverhas a keyless chuck that allows you to hand
tighten or release drill bit in the chuck jaws.
SWITCH
To turn your drill-driver ON, depress the switch trigger.
Release switch trigger to turn your drill-driver OFF.
SWITCH
LOCK
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use.
VARIABLE
SPEED
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression,
"PNO SPEED
GEAR TRAIN
Your drill-driver has a two speed gear train designed for
drilling or driving at HI or LO speeds. A slide switch is
located on top of your drill to select either HI or LO speed,
FORWARD/REVERSE
SELECTOR
(DIRECTION
OF ROTATION SELECTOR)
Your drill-driver has a forward/reverse selector located
above the switch trigger.
WRIST
STRAP
A wrist strap is provided to reduce the chances of dropping
your drill-driver. Place one hand through the wrist strap
when carrying tool.
_,
WARNING:
If any parts are missing, do not operate
your drill-driver untilthe missing parts are replaced.
Failure to do so could result in possibleserious
personal injury.
Advertisement
