Charging A Hot Battery Pack; To Install Battery Pack; To Remove Battery Pack - Craftsman 315.116400 Operator's Manual

CHARGINGA HOTBATTERYPACK
Whenusing thetoolcontinuously, thebatteries inthe
battery packwillbecome hot.Youshouldleta hotbattery
packcooldownforapproximately 30minutes before
attempting t o recharge. When the battery packbecomes
discharged a ndis hot,thiswillcausethegreen LEDto
comeon instead ofthe redLED. A fter30minutes, r einsert
thebattery packinthecharger. Ifthe green LEDcontinues
to remain on, returnbattery packto yournearest Sears or
otherqualified service center f orchecking or replacing.
NOTE: T hissituation onlyoccurswhen continuous u seof
thetoolcauses the batteries t o become hot.It doesnot
occurundernormal c ircumstances. Refer t o CHARGING
A COOLBATTERY P ACK for normal r echarging o f
batteries. I fthecharger d oesnotcharge yourbattery
packunder normal c ircumstances, returnboththebattery
packandcharger t o yournearest Searsor otherqualified
service centerforelectrical check.
BATTERY PACK
SHOWNIN CHARGER
TO iNSTALL BATTERY PACK
See Figure 3.
[] Lock switch trigger on the drill by placing the direction
of rotation selector in center position.
[] Place battery pack in the drill. Align raised rib on
battery pack with groove inside drill.
CAUTION: When placing battery pack in the drill,
be sure raised rib on battery pack aligns with groove
inside drill and latches snap into place properly.
Improper assembly of battery pack can cause damage
to internal components.
[] Make sure the latches on each side of your battery
pack snap in place and battery pack is secured in drill
before beginning operation.
TO REMOVE BATTERY PACK
See Figure 3.
[] Lock switch trigger on the drill by placing the direction of
rotation selector in center position.
[] Locate latches on side of battery pack and depress to
release battery pack from the drill.
[] Remove battery pack from the drill.
CHARGER
RED LED
GREENLED
YELLOW
LED
Fig. 2
BATTERY
PACK
DEPRESS LATCHES TO
RELEASEBATTERY PACK
LATCHES
Fig. 3
11