ProForm 975S User Manual page 5

1. Loosen the LockKnob(68)on therightsideofthe
Frame (1). SlidetheSeatFrame(3)outuntilit
stops.33ghten t he LockKnob.
Identify the RearStabilizer (73)(therearenowheels
ontheRearStabilizer). Attachthe Rear S tabilizer to
theSeatFrame (3)withtwoM1O x 58mmCarriage
Bolts(74)andtwoM10Nylon Locknuts ( 72).
2. Identify the FrontStabilizer (75),whichhaswheels
attached to it.Attach the FrontStabilizer (75)tothe
Frame (1)withtwoM10x 58mmCarriage Bolts(74)
andtwo M10NylonLocknuts ( 72).
3. Attachthe Upright ( 2)to the Frame (1)withthree
M10x 25mmButton HeadScrews (25)andthree
MlO Split Washers (26). Be careful not to pinch
the Reed Switch Wire (13) or the Resistance
Cable (10).
4. Route both Extension Wires (41) up through the
Uptight (2) as:shown.
Attach the Handlebar (4) to the Upright (2) with two
M6 x 25mm Hex Head Screws (14) and two M6 Split
Washers (67), but do not tighten the Screws yeL
Make sure that the Screws are threaded into the
indicated holes. Note: Two additional Screws will
be attached in step 6.
2
72
73
25
26\
/
25
4
_14
67
41
4
5