Epson Stylus NX105 Service Manual page 98

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300
6. Disengage the shafts on both ends of the CIS Unit from the bearing holes of
the Scanner CR Holder, and remove the unit.
CIS Unit
Scanner CR Holder
Figure 4-111. Removing the CIS Unit
DISASSEMBLY/ASSEMBLY
Shaft and Shaft hole
Disassembling the Scanner Unit
Install the CIS springs (x2) to the dowels of the Scanner CR
Holder. (See Fig.4-112.)
Dowel
CIS Spring
Figure 4-112. Installing the CiS Spring
When installing the spacers, be sure to place them with the
cutout facing inward. (See Fig.4-113.)
Figure 4-113. Replacing the Spacers
Revision A
Scanner CR Holder
Spacer
98
Confidential