Epson Stylus NX105 Service Manual page 92

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300
8. Release the hook of the Combination Gear, and remove the gear from the ASF
Housing.
9. Remove the Lever Pick Clutch from the ASF Housing.
Hook
ASF Housing
Figure 4-93. Removing the Lever Pick Clutch
10. Disengage the Lever Clutch Spring from the ribs of the Change Lever, and
remove the Lever Clutch Spring.
11. Remove the Lever Idle Gear from the Change Lever.
Change Lever
Lever Idle Gear
Figure 4-94. Removing the Change Lever
DISASSEMBLY/ASSEMBLY
Combination Gear
Lever Pick Clutch
Ribs Rear
Lever Clutch Spring
Disassembling the Printer Mechanism
When installing the ASF Unit, insert the guide pin of the Lower
Housing to the positioning hole of the unit, and secure the unit
with the hook of it and the three screws. (See Fig.4-91.)
When installing the LD Roller Assy and the ASF Unit, make
sure to engage the cam face of the LD Roller Assy and that of
the Paper Back Lever.
Cam Face of the LD Roller Assy
Cam Face of the Paper Back Lever
Figure 4-95. Installing the ASF Unit
When installing the LD Roller to the LD Roller Assy, make sure
to attach it with the arrow inside as shown below.
LD Roller Assy
LD Roller
Paper feed side
Figure 4-96. Assembling the LD Roller Assy (1)
Revision A
Paper eject side
92
Confidential