Epson Stylus NX105 Service Manual page 41

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300
Occurrence
timing Detailed phenomenon
CR position
• Operation
The drive of the PF Motor is not
transmitted to the LD Roller Shaft.
• –
TROUBLESHOOTING
Table 3-5. Check point for Paper out error according to each phenomenon
Defective
unit/part name
1. Check if the Extension Spring comes off from the Clutch
mechanism.
2. Check if the positioning hole of the Clutch comes off
LD Roller
from the guide pin of the LD Roller Shaft.
Assy
LD Roller Shaft
3. Check if the Clutch tooth is damaged.
4. Check if the Clutch is damaged.
1. Check if the Compression Spring comes off from the
Change Lever.
ASF Unit
Error Indications and Fault Occurrence Causes
Check point
Extension Spring
Guide pin
Clutch
Compression Spring
Change Lever
Revision A
Remedy
1. Reassemble the Extension Spring in the Clutch
mechanism.
2. Reassemble the positioning hole of the Clutch
on the guide pin of the LD Roller Shaft.
3. Replace the LD Roller Assy with a new one.
4. Replace the LD Roller Assy with a new one.
1. Replace the Change Lever and Compression
Spring with new ones.
Confidential
41