Download Print this page

Fujitsu MB15F74UL Datasheet page 11

Dual serial input pll frequency synthesizer
Hide thumbs

Advertisement

3. Power Saving Mode (Intermittent Mode Control Circuit)
Status
Normal mode
Power saving mode
The intermittent mode control circuit reduces the PLL power consumption.
By setting the PS pin low, the device enters into the power saving mode, reducing the current consumption. See
the Electrical Characteristics chart for the specific value.
The phase detector output, Do, becomes high impedance.
For the dual PLL, the lock detector, LD, is as shown in the LD Output Logic table.
Setting the PS pin high, releases the power saving mode, and the device works normally.
The intermittent mode control circuit also ensures a smooth startup when the device returns to normal operation.
When the PLL is returned to normal operation, the phase comparator output signal is unpredictable. This is
because of the unknown relationship between the comparison frequency (fp) and the reference frequency (fr)
which can cause a major change in the comparaor output, resulting in a VCO frequency jump and an increase
in lockup time.
To prevent a major VCO frequency jump, the intermittent mode control circuit limits the magnitude of the error
signal from the phase detector when it returns to normal operation.
Notes : When power (VCC) is first applied, the device must be in standby mode.
PS pin must be set "L" at Power-ON.
(1) PS
L (power saving mode) at Power-ON
(2) Set serial data at least 1 s after the power supply becomes stable (V
(3) Release power saving mode (PS
PS pin
H
L
OFF
V
CC
t
V
Clock
Data
LE
PS
(1)
, PS
: "L"
IF
RF
ON
1 s
t
100 ns
PS
(2)
(3)
CC
"H") at least 100 ns later after setting serial data.
MB15F74UL
2.2 V) .
11

Advertisement

loading

  Related Manuals for Fujitsu MB15F74UL