Replacing Non-Server Hardware - Fujitsu ServerView Resource Orchestrator Cloud Edition V3.1.1 Operation Manual

For details on BIOS settings, refer to "8.2 Configuring the Server Environment" in the "Design Guide CE".
Shut down the server after completing BIOS settings.
3.
Reconfigure Hardware Properties after Replacement
After replacing the server, reconfigure Resource Orchestrator with the latest hardware properties.
For details on how to reconfigure hardware properties, refer to
After hardware properties have been reconfigured, the maintenance LED is automatically turned off in the ROR console.

9.2.4 Replacing Non-Server Hardware

This section explains how to replace hardware external to servers.
-
Replacing Chassis
No specific action is required in Resource Orchestrator.
-
Replacing Management Blades
No specific action is required in Resource Orchestrator.
-
Replacing LAN Switch Blades
No specific action is required for PRIMERGY BX900/BX400 LAN switch blades in IBP mode.
For other LAN switch blades of PRIMERGY BX models, after replacing a switch blade, update the new LAN switch blade with the
VLAN settings that were previously configured in Resource Orchestrator.
Use the following procedure to replace a LAN switch blade.
1.
Replace the faulty LAN switch blade.
2.
Restore the LAN switch blade configuration backup (which includes all of the LAN switch blade settings) to the new LAN
switch blade.
For LAN switch blades (PY CB DCB SW 10Gb 18/6/6), the Automatic Migration of Port Profile (AMPP) configuration of all
ports and VLAN settings of external ports must be restored manually.
If the LAN switch blade configuration was not been backed up in advance, it has to be restored by configuring each setting
(except VLAN settings) to the same values set during the initial installation.
Refer to the manual of the LAN switch blade used for details on how to back up and restore LAN switch blade configurations.
3.
Update the new LAN switch blade with the latest VLAN settings configured in Resource Orchestrator.
a.
In the ROR console server resource tree, right-click the target LAN switch, and select [Restore] from the popup menu.
The [Restore LAN Switch] dialog is displayed.
b.
Click <OK>.
VLAN settings are applied to the specified LAN switch blade.
For LAN switch blades (PY CB DCB SW 10Gb 18/6/6), only the VLAN settings of internal ports for which an Automatic
Migration of Port Profile (AMPP) has not been configured are restored.
Note
To replace LAN switch blades with different models, first delete the registered LAN switch blade, and then register the replacement
LAN switch blade.
After the LAN switch blade is registered, the VLAN settings must be configured for the internal and external ports.
For details on the VLAN settings, refer to "5.4.4 Configuring VLANs on LAN Switch Blades" in the "User's Guide for Infrastructure
Administrators (Resource Management) CE".
When the following configurations before and after replacement of a PRIMERGY BX900/BX400 series LAN switch blade are
different, delete the registered LAN switch blade and register it again.
-
Operation mode (IBP and another mode, VCS and another mode)
-
VCS ID
"9.3.1 Reconfiguration of Hardware
- 52 -
Properties".