Fru Replacement Preparation; Tools Required For Maintenance - Fujitsu SPARC Enterprise M3000 Service Manual

4
C H A P T E R

FRU Replacement Preparation

This chapter explains the method of preparing for the safe replacement of FRUs.
Section 4.1, "Tools Required for Maintenance" on page 4-1
■
Section 4.2, "FRU Replacement and Installation Methods" on page 4-2
■
Section 4.3, "Active Replacement/Active Addition" on page 4-5
■
Section 4.4, "Hot Replacement/Hot Addition" on page 4-7
■
Section 4.5, "Cold Replacement/Cold Addition" on page 4-12
■
4.1

Tools Required for Maintenance

The actual maintenance work described in
maintenance software to confirm that the server and other components are operating
correctly and to collect status information and log data on the server and
components. Work for mounting, removing, or replacing a specific component
requires special tools, including screwdrivers and an antistatic wrist strap. These
items are generally named maintenance tools and are listed in
Maintenance Tools
TABLE 4-1
Item Part Name
1 Phillips screwdriver (No. 2)
2 Wrist strap
3 Conductive mat
4 Oracle VTS
Chapter 5
Use
For electrostatic control
For electrostatic control
Test program
to Chapter 15 requires
.
TABLE 4-1
4-1