Advanced - NetComm Liberty series User Manual

Advanced

this page allows you to modify the advanced wireless settings for your 3G Router. these settings should not be changed unless you are
aware of what effect they will have.
Name
Beacon Interval:
Data Beacon Rate (DTIM):
Fragment Threshold:
RTS Threshold:
AP Isolation:
TX Power:
WMM Capable:
WMM Parameters:
Broadcast Network Name (SSID):
Click Apply to save the settings.
YmL1�WN 1�WN
www.netcomm.com.au
NetComm Liberty Series - Wireless N150 Router
Description
Interval of time the wireless router broadcasts a beacon, used to synchronize
the wireless network.
Enter a value between 1 and 255 for the Delivery Traffic Indication Message
(DTIM). A DTIM is a countdown informing clients of the next window for listening
to broadcast and multicast messages
This specifies the maximum size of a packet during the fragmentation of data to
be transmitted. If you set this value too low, it will result in bad performance.
When the packet size is smaller than the RTS threshold, the wireless router will
not use the RTS/CTS mechanism to send this packet.
This feature allows you to isolate clients on your wireless network. To enable
communication between the wireless clients connected to your 3G Router,
select Disabled. to cut the communication between the wireless clients, please
choose enabled.
this determines the output power of the antenna
WMM (Wi-Fi Multimedia) if enabled supports QoS (Quality of Service) for
experiencing better audio, video and voice in applications
Click on the WMM Configuration button to configure the WMM parameters
Select 'Disabled' to hide the SSID of your 3G Router. If disabled, other people
will not be able scan and detect this product's SSID.
NetComm Liberty Series 3G Wireless N150 Router NetComm Liberty Series 3G Wireless N150 Router NetComm Liberty Series 3G Wireless N150 Router 3G Wireless N150 Router
�