Table of Contents
Advertisement
Chapter 3
Power Again
This item determines how the system will power on after a power failure.
Power Off
Power On
Last State
Sleep State LED
This item determines which state the Power LED will use. The settings
are [Single], [Dual] and [Blinking]. When set to [Blinking], the power
LED will blink when the system enters the suspend mode. When set to
[Dual], the power LED will change its color. Choose the [Single] and the
power LED will always remain light up.
Reload Global Timer events are I/O events whose occurrence can pre-
vent the system from entering a power saving mode or can awaken the
system from such a mode. In effect, the system remains alert for anything
which occurs to a device which is configured as Enabled , even when the
system is in a power down mode.
Leaves the computer in the power off state
Reboots the computer
Restores the system to the state before power failure
<Reload Global Timer Events>
Primary Master IDE
Primary Slave IDE
Secondary Master IDE
Secondary Slave IDE
FDC/LPT/COM Ports
3-26
Advertisement
Table of Contents
