Table of Contents
Advertisement
SCSI LED Connector: J7
Connect the J7 to the LED connector on the add-on SCSI adaptor and the HDD LED will
blink when add-on SCSI device is active.
Fan Power Connectors: CFAN1/2, SFAN1, NBFAN1
The fan power connectors support system cooling fan with +12V. W hen connecting
the wire to the connectors, always note that the red wire is the positive and should
be connected to the +12V; the black wire is Ground and should be connected to GND.
If the mainboard has a System Hardware Monitor chipset onboard, you must use a
specially designed fan with speed sensor to take advantage of the CPU fan control.
CFAN1/
SFAN1
MSI Reminds You...
Please refer to the recommended CPU fans at AMD
or consult the vendors for proper CPU cooling fan.
Pin Definition
J7
1
SENSOR
+1 2V
GND
CFAN2
Hardware Setup
PIN
SIGNAL
1
VCC5
2
SCSI LED
3
HDD LED
4
VCC5
+1 2V
GND
NBFAN1
®
official website
2-17
Advertisement
Table of Contents
