MS-9617 ATX Workstation Board
u For CPU1
1.
Locate the CPU and its retention mod-
ules on the motherboard.
retention modules
3.
Hook one end of the clip into the hole
of the retention module, then push
down the handle to hook the other
end to the retention module.
handle
2-6
2.
Position the heatsink/cooler onto the
retention modules. Connect the wires
to the fan power connector (CFAN1),
then press down the fan until its four
clips get wedged in the holes of the
retention modules.
fan power
4.
Repeat step 3 on the other clip.