Saving Master Compressor Settings
The Master Compressor settings you have edited on page 88 can be saved as the User Compressor type.
1
Press the [I] (SAVE) button to enter the USER MASTER COM-
PRESSOR display.
2
Select the destination to which the User Master compressor is
to be stored, by using the [3 ]–[6 ] buttons.
3
Press the [I] (SAVE) button to open the SAVE display.
4
Enter the name of the edited Compressor type (page 31), then
press the [8 ] (OK) button.
5
Press the [EXIT] button to return to the previous display.
The saved Compressor type is shown in the TYPE selection at the bottom left of
the display.
Advanced Features
Refer to the Reference Manual on the website, Chapter 9.
Editing VOL/VOICE parameters:
Editing FILTER parameters:
Editing TUNE parameters:
Changing an Effect type:
Editing EQ parameters:
LINE OUT Settings:
1
MIXING CONSOLE display TAB [][] VOL/VOICE
MIXING CONSOLE display TAB [][] FILTER
MIXING CONSOLE display TAB [][] TUNE
MIXING CONSOLE display TAB [][] EFFECT [F] TYPE
MIXING CONSOLE display TAB [][] EQ
MIXING CONSOLE display TAB [][] LINE OUT
2
Tyros4 Owner's Manual
3
9
89