Changing the Network Configuration
Use the Network Configuration menu to set the bootup option, configure
the switch's Internet Protocol (IP) parameters, enable the on-board Web
server, or to set the number of concurrent Telnet sessions allowed. The
screen shown below is described in the following table.
Parameter
IP Configuration
IP Connectivity Test
HTTP Configuration
MAX Number of
Allowed Telnet
Sessions
Physical Address
9033640
Vertical Horizon Local Management -- VH-8G
Network Configuration
IP Configuration ...
IP Connectivity Test (Ping) ...
HTTP Configuration ...
MAX Number of allowed Telnet sessions (1 -4) : 4
Physical Address : 00-E0-29-52-28-00
<APPLY>
Use <TAB> or arrow keys to move. <Enter> to select.
Figure 2-7. Network Configuration
Description
Screen used to set the bootup option, or configure the switch's IP
parameters.
Screen used to test IP connectivity to a (Ping) specified device.
Screen used to enable the Web server.
The maximum number of Telnet sessions allowed to
simultaneously access the switch.
MAC address of the switch.
<OK>
<CANCEL>
VH-8G User Interface 13