Tire Care; To Remove Wheel; To Remove Belt Guard; To Replace Ground Drive Belt - Craftsman 917.293490 Owner's Manual

TIRE CARE
_kCAUTION: When mounting tires, unless
beads are seated, ovednflation can
cause an explosion.
• Maintain 20 pounds of tire pressure. If
tire pressures are not equal, tiller will
pull to one side.
• Keep tires free of gasoline or oil which
can damage rubber.
TO REMOVE WHEEL
1, Place blocks under transmission to
keep tiller from tipping.
2, Remove hairpin clip and clevis pin
from wheel.
3, Remove wheel and tire.
4, Repair tire end reassemble.
Clevis Pin
HairpinClip
TO REMOVE BELT GUARD
NOTE: For ease of removal, remove
hairpin clip and clevis pin from left wheel.
Pull wheel out from tiller about 1 inch.
1. Remove two (2) screws from side of
belt guard.
2. Remove hsx nut and washer from
bottom of belt guard (located behind
wheel).
3. Pull belt guard out and away from unit.
4. Replace belt guard by reversing
above procedure.
Hex Nut
f/j/;n
y_,_ Washer
.J_ (Located
"_,_ Behind
HairpinClip andClevis Pin
TO REPLACE GROUND DRIVE BELT
I. Remove belt guard as described in
"TO REMOVE BELT GUARD".
2, Remove old belt by slipping off engine
pulley first then remove from transmis-
sion pulley.
3. Place new belt in groove of transmis-
sion pulley and into engine pulley.
BELT MUST BE IN GROOVE ON TOP
OF IDLER PULLEY. NOTE POSITION
OF BELT TO GUIDES.
4. Check belt adjustment as described
below.
5. Replace belt guard.
6. Reposition wheel and replace clevis
pin and hairpin clip.
GROUND DRIVE BELT ADJUSTMENT
For proper belt tension, the extension
spring should have about 5/8 inch stretch
when drive control bar is in "ENGAGED"
fosition. This tension can be attained as
ollows:
1. Loosen cable clip screw securing the
drive control cable.
2. Slide cable forward for less tension
and rearward for more tension until
about
5/8 inch stretch is obtained while the
drive control bar is engaged.
3. Tighten cable clip screw securely.
, Screw
Drive Control Cable
Idler Pulley
Transmission Pulley
More Tension
17