Adjust Wheels For Cultivating - Craftsman 917.293490 Owner's Manual

ADJUSTWHEELS FOR
CULTIVATING
1. Place blocks under right hand side of
tiller and remove hairpin clip and
clevis pin from right hand wheel.
2. Move wheel outward approximately 1
inch until hole in inner wheel hub
lines up with inner hole in axle.
3. Replace clevis pin and hairpin clip on
inside of wheel and remove blocks.
4. Repeat preceding steps on left hand
side.
NOTE: In extremely rough conditions
and while cultivating, the wheels should
be moved outward on the axle for
increased stability.
Clevis "_
Pin
OUTER VIEW OF TIRE
_1_ HairpinCllip
INNER VIEW OF TIRE
13