Your new tiller has been assembled at the
factory with exception of those parts left
unassembled for shipping purposes. To
ensure safe and proper operation of your
tiller all parts and hardware you assemble
must be tightened securely. Use the
correct tools as necessary to insure
proper tightness.
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) Utility knife
(1) Wire cutter
(1) Tire pressure gauge
(t) Screwdriver
(1) Pair of pliers
(1) 9/16" wrench
OPERATOR'S
POSITION
When right or left hand is mentioned in
this manual, it means when you are in the
operating position (standing behind tiller
handles).
FRONT
OPERATOR'S
POSITION
RIGHT
CONTENTS OF HARDWARE PACK
(2) Handle Locks
(1) Center Locknut
(1) Carriage
Bolt
3/8-16 UNC
3/8-16 UNC x 1 Gr. 5
(1) Hairpin Clips
,
(1) Flat Washer
13/32 x 1 x 11 Ga.
°l
(2) Shear Pins & Clips
(1) Cable Clip
(1) Pivot Bolt
3/8-16
UNC Grade 5
O
(1) Handle Lock Lever
%