Advertisement
Available languages
Available languages
PRODUCT
SPECIFICATIONS
HORSEPOWER
11 HP
DISPLACEMENT
21.82 cu, in.
GASOLINE
4 quarts
CAPACITY
(unleaded)
OIL CAPACITY
5W30
(20 oz capacity)
SPARK PLUG:
Champion RJt 9LM
(Gap ,030 in.) or
equivalent
VALVE CLEARANCE:
Intake: ,010 In,
Exhaust: ,010 In,
SNOW THROWER
AS REQUIRED
The following
adjustment
should
be
preformed
more than
once each sea-
son.
1. Auger drive belt should be adjusted
after the first 2 to 4 hours of use,
again about mid-season
and twice
each season thereafter (See to Ad-
just Belts paragraph
in the Ser-
vice and Adjustment
section).
LUBRICATION - EVERY 10 HOURS
1. Auger Shaft - Using a hand grease
gun, lubricate the auger shaft zerk
fittings (A) every ten (10) operating
hours. Each time a shear bolt is re-
placed, the auger shaft MUST be
greased.
See Figure 19. See To
Replace Auger Shear Bolt in the
Service and Adjustment
section.
Figure 19
CHAIN LUBRICATION
EVERY 25 HOURS
1. Position speed selector lever in first
(1) forward gear.
2. Stand the snow blower up on the
auger housing end.
NOTE: When the crank case if
filled with oil, do not leave the
snow blower
standing up on the
auger housing
for an extended
period of time.
3. Remove the bottom panel.
4. Lubricate the chains with a chain
type lubricant.
5. For storage, wipe the hexshaft
and
sprockets with 5W30 motor oil.
NOTE: Clean all excess grease or
oil found on the rubber friction
wheel or the disc drive plate.
CAUTION:
Do not allow grease or
oil to contact the rubber friction
wheel or the disc drive plate.
6. Install the bottom panel.
Figure 20
F-011047L
20
Advertisement
