Table of Contents
Advertisement
•
Place the flow control lever into the slot in the
hopper. See figure 8.
•
Place the center brace into the hopper. Insert the
1/4" x 1" hex bolt through the center brace and the
front of the hopper. Assemble
a 1/4" flat washer,
the flow control lever and a 1/4" hex lock nut onto
the bolt. Do not tighten yet. See figure 8.
•
Insert the 1/4" x 3/4" hex bolt through the center
brace and the rear of the hopper. Assemble
a 1/4"
flat washer and 1/4" hex lock nut onto the bolt.
Tighten both the front and rear bolts. See figure 8.
S
1/4" x 1"
CENTER
BRACE
HEX BOLT
// 1/4" FLAT
.
1/4" x 3/4"
II
WASHER
HEX BOLT
1/4" HEX
FIGURE 8
FLAT
WASHER
1/4" HEX
LOCK NUT
•
Insert the 5/16" x 1-3/4'! carriage
bolt up through
the slot and secure it with a nylon washer and the '
plastic wing nut. See figure 9.
•
Move the lift handle into the locked position as
shown in figure 9 and then tip the spreader
back to
rest on the wheels and the rear of the hopper.
PLASTIC WING NUT
NYLON
WASHER
5/16" x 1-3/4"
CARRIAGE BOLT
LOCKED POSITION
FIGURE 9
•
Place a nylon washer onto the bent end of the flow
control link and then insert the end of the link into the
hole in the feed plate bracket. Secure it with a 3/32" x
3/4" cotter pin. See figure 10.
•
Adjust the 1/4" hex lock nut to make it flush with the
end of the flow control link, the screw the 1/4" plain
hex nut until it is tightened securely against the
bottom of the ferrule. See figure 10.
•
Hook the open end of the spring into the hole in the
feed plate that is nearest the bracket. Place the
closed end of the spring onto the end of the hex bolt
assembled through the flow control lever. Secure it
with a 1/4" hex lock nut. See figure 10.
FLOW _
CONTROL
1/4" HEX
NUT
SPRING
FLOW
FIGURE 10
r
:e
3/32" x 3/4"
co'n'ER PIN
NYLON
WASHER
Push two flange bearings
into each of the drive
disk assemblies.
See figure 11.
DRIVE DISK
ASSEMBLY
FLANGED
BEARING
FLANGED
BEARING
/
FIGURE 11
8
Advertisement
Table of Contents
