•
Place two 5/8" flat washers separated
by a metal
spacer tube onto the shaft. See figure 20.
5/5" FLAT WASHER
•
Place a 5/8" flat washer onto the end of the spike disk
shaft and secure the shaft with a 1/8" x 1-1/2" cotter
pin. See figure 22.
•
Fasten the two drive disks to the shaft using two 1/8"
x 1-1/2" cotter pins. See figure 22.
1/8" x 1-1/2"
COTTER PIN
FIGURE 20
5/8" FLAT
WASHER
Place a spike disk and a plastic spacer tube onto
the shaft. Fit the plastic spacer tube onto the ends
of the flanged bearings
in the spike disk and in the
end plate. Push the shaft on through the flanged
bearing in the end plate. See figure 21.
FIGURE 21
\
SPIKE DISK
PLASTIC SPACER TUBE
FIGURE 22
•
Assemble
the chain onto the two sprockets
on the
left side of the hopper. Fasten the ends of the
chain together using the connecting
link. See figure
23.
•
Place the chain cover over the chain and fasten it to
the hopper end plate using two self tapping screws.
See figure 23.
SELF
TAPPING
SCREW
FIGURE 23
11