Using The Access Point 2000 Console Port - Enterasys 802.11 Networking Manual

Using the Access Point 2000 Console Port

To set up Rapid Rekeying using the console port, perform the following steps:
1. Choose Module-Specific Options from the Installation Menu.
2. Choose Authentication Options.
3. Choose Configure Wireless Authentication Type.
4. Choose 802.1X Authentication with Rapid Rekeying.
5. Enter the 802.1X activation key, then enter the 802.1X parameters as described in
"Configuring the AP for Authentication" on page
6. Choose Configure Rapid Rekeying Parameters from the Authentication Options
menu.
7. Enter the Rapid Rekeying parameters.
8. Choose Save. There is no need to reset the AP.
Configuring for Rapid Rekeying
5-32.
5-37