Enterasys 802.11 Networking Manual page 162

802.11 wireless
Hide thumbs Also See for 802.11:
Table of Contents

Advertisement

Showing Counters
Table 7-10: RoamAbout AP Classic and 2000) PC Card Counters (Cont'd)
Counter
Wrong station address on
transmit
(TxDiscardsWrongSA)
Receive WEP errors
(RxDiscardsWEP
Undecryptable)
Receive message in
message fragments
(RxMessageInMsg
Fragments)
Receive message in bad msg
fragments (RxMessage
InBadMsgFragments)
Receive WEP ICV errors
Receive WEP excluded
7-16
Description
Number of times a message transmission was not done because a wrong
MAC address was used by the protocol stack. A non-zero value indicates an
error situation in the communication between the driver and protocol stack.
Number of times a received message was discarded because it could not be
decrypted by the PC Card. This means that:
Both devices have enabled encryption, but use keys that do not match.
One of the devices does not support encryption or does not have
encryption enabled.
Use RoamAbout Client Utility Link Test, Configuration Info tab, to see the
configuration of the client and the AP or other client.
Number of times messages were received while another transmission was
in progress. It is a measure of the amount of overlapped communication in
your system. Zero values indicate low to moderate load of your network.
Non-zero values identify a wireless medium that is being used
simultaneously by multiple users.
Number of times messages were received while a transmission elsewhere in
the wireless network was in progress. This counter is expected to be zero.
Non-zero-values indicate a heavily loaded system.
Increments when encrypted data has an error that prevents it from being
deciphered. A high number indicates a mismatched encryption key. A low
number can be caused by drop bits which can be ignored.
Increments when this device sends unencrypted data to another device
which rejects the data. If this is a client in an infrastructure network, this can
be caused when the client has encryption disabled and the AP is configured
to accept encrypted data only (DENY NON-ENCRYPTED DATA is
enabled).

Advertisement

Table of Contents
loading

Table of Contents