Table of Contents
Advertisement
By connecting the camera to a VCR, you can edit your recordings in order to
remove unwanted scenes -- or combine different shots to create your own video
productions.
1. Connect
the camera
to the VCR.
• See "Connections for Playback on a TV Screen" on p. 28.
2. Prepare
the TV and VCR.
, Turn on the TV and set the TV/VIDEO selector to VIDEO.
, Turn on the VCR, and set its input selector to LINE. Load a blank cassette,
and put the VCR in record pause mode.
• See your TV and VCR instruction manuals for details.
3. Turn
the camera's
POWER
dial to VCR, and load your recorded
cassette.
1. Find
a point
on your recorded
cassette
slightly
before
the section
you want to copy.
2. Start
to play it back while you monitor
the picture
on the TV.
3. Start
recording
on the VCR as soon as the section
you want to copy
appears
on the screen.
Pause
the VCR at the end of the section
you want to copy, then stop
playback
on the camera.
Repeat
steps 1 to 4 until your edited
recording
is complete.
[]
, The quality of the edited tape will be slightly lower than that of the original.
.
I-
W
80
The I_ terminal allows you to connect
the camera to equipment. Some buttons
on editing equipment may operate
differently from those on the camera,
[]
" 1_ (LANC) is a trademark. It stands for Local Application Control Bus System.
, We cannot guarantee the results when connecting to equipment not bearing the
LANC _ symbol.
Hide quick links:
Advertisement
Table of Contents
