Canon ELURA 2 MC Instruction Manual page 15

To protect your recording from accidental erasure, slide the tab on the cassette so
that it exposes the hole. (This switch position is usually labeled SAVE o1 ERASE
OFF.)
If you load this cassette and put the camera hi record pause mode ( [22_1 16), "THE
TAPE IS SET FOR ERASURE PREVENTION" is displayed for approx. 4
seconds and then the _T mark flashes in the display. The canlera also shows the
above phrase if you accidentally press the REC PAUSE button on the camera or
the wireless controller with the camera switched to VCR mode.
If you want to record on the cassette again, slide the tab back so the hole is closed.
• To protect the tape heads, transfer cassettes directly fiom the tape case to the
camcorder -- do not open the tape protect cover or touch the tape itself.
, Do not use cassettes where the tape has been damaged or spliced -- they may
damage the camcorder
, Do not insert anything into the small holes on the cassette or cover them with
cellophane tape.
, Handle cassettes with care -- dropping them or exposing them to external
shocks may cause internal damage.
, Store cassettes in the provided case, first rewinding them to the start of the tape
and then storing them upright.
, A cassette with metal plated terminals may become dirty with use, affecting
information transfer Therefore, after using a tape about 10 times, be sure to
clean the terminals with a cotton swab.
/
,.*g:
gg
You are unable to use the cassette memory fnnction with this camcordm:
15