Canon ELURA 2 MC Instruction Manual page 47

Ariel you set the date and thne, the date/time and home time zone will be
displayed for about 4 seconds each time you turn the power on.
M..U, [.SYSTEM [.0TME ET JAN 1 2000112:00
1. Open the menu and select SYSTEM.
2. Select D/TIME SET.
. The year display starts to flash.
3. Turn tile SELECT dial up and down to change tile year. Press tile
dial in to move to another part of the display.
• Once you move from the yea1: the next part of the display starts flashing.
4. Set the month, day, hours, and minutes in the same way.
5. Press the MENU button when finished, and to start the clock.
[]
• To make a change to part of the date and time, press the SELECT dial in at step
3 to move to the part to be changed. Turn the dial to make the change, then
3at
close the menu. _
• The date can be set to any year between 2000 and 2030. _ _ "_"
• If you press the MENU button in the middle of setting the date and time, you o
"_¢D
leave the menu, and the clock starts.
• If you press the SELECT dial in after setting the minutes you can set the date _ =
e:
and time again fiom the start.
You can choose to display or hide the date and time display during recording.
When the date and time display is set to ON, the date and time show- in the lower
left-hand corner of the display but the thne zone disappears in about 4 seconds.
The large, 4-second display will no longer appear when you turn on the power. [t
is not automatically superhnposed on your recordings.
MENU( _
34) [_-DI SP.$ET UP
_[ _D/TDISPLAY.OFF
To turn it on, open the menu and select DISESET UP. Then select D/T
DISPLAY, set it to ON and close the menu.
47