Ariens ProZoom 99480600-1952S Owner's/Operator's Manual page 23

13. Unlock park brake.
CAUTION: Avoid injury! Help prevent serious bodily
injury. Remain alert to other people and the surroundings
when operating the machine.
14. Cycle motion control levers forward and rearward several
times. Check for leaks around filter.
15. Stop engine. Check oil level. Add oil as necessary to bring oil
level to FULL mark on dipstick.
Cleaning Hydraulic Oil Pump Cooling Fins
CAUTION: Avoid injury! Compressed air can cause
debris to fly a long distance.
• Clear work area of bystanders.
• Wear eye protection when using compressed air for
cleaning purposes.
• Reduce compressed air pressure to 210 kPa
(30 psi).
Checking and Replacing Pump Traction
Drive Belt
,_ CAUTION: Avoid injury! Fingers or loose clothing can
get caught in rotating parts. Stop engine and wait for all
moving parts to stop before servicing.
NOTE: The traction drive belt will not require a tension adjustment.
Belt is self-adjusted using a spring tensioner.
Checking Traction Drive Belt:
1. Park machine safely. (See Parking Safely in the SAFETY
section.)
IMPORTANT: Avoid Damage! To ensure proper cooling, keep
the cooling fins clean at all times. Operating the machine with
obstructed cooling fins could cause damage due to
overheating.
1. Park machine safely. (See Parking Safely in the SAFETY
section.)
2. Remove two cap screws (A).
3. Remove rear shield (B).
2. Remove four cap screws (A).
3. Remove rear shield (B) to access hydraulic pumps (C).
4. Clean hydraulic oil cooling fins on each hydraulic pump with a
rag, brush or compressed air.
5. Clean area around hydraulic pumps and frame.
4.
MX20111
GB - 23
Inspect belt (C) through frame openings (D) for excessive
wear, damage or stretching.