Related Manuals for Antec SONATA II
Summary of Contents for Antec SONATA II
- Page 1 SONATA II User’s Manual Manuel de l’utilisateur Anwenderhandbuch Manuale per l’operatore Manual del usuario...
- Page 2 At Antec, we continually refine and improve our products to ensure the highest quality. So it's possible that your new case may differ slightly from the descriptions in this manual. This isn't a problem; it's simply an improvement. As of the date of publication, all features, descriptions, and illustrations in this manual are correct.
- Page 3 I/O panel, a power cord. You will also find a bag of hardware (screws, brass standoffs, plastic stands, etc.) 5. Lay the case down with the open side facing up. You need to remove the Antec Chassis Air Guide (ACAG) before your motherboard installation. To remove the ACAG: 6.
-
Page 4: Installing The Motherboard
INSTALLING THE MOTHERBOARD This manual does not cover CPU, RAM, or expansion card installation. Please consult your motherboard manual for specific mounting instructions and troubleshooting. 1. Lay the case down, with the open side facing up. The drive cages and power supply should be visible. -
Page 5: Connecting The Audio Ports
Note: Please check your motherboard manual for your USB header pin layout and make sure it matches the attached table. If it does not match this Intel standard, please call Antec customer support at (800) 22ANTEC (North America) or at +31 (0) 10 462-2060 (Europe) to buy a USB adapter. -
Page 6: Device Installation
2. Microphone Power: Connect the MIC-BIAS connector to this pin. 3. Ground Pin: Connect the AUD GND connector to this pin. 4. Front Right Speaker Out Pin: Connect the FPOUT-R connector to this pin. 5. Front Right Speaker Out Pin: Connect the FPOUT-L connector to this pin. 6. -
Page 7: Cooling System
The front fan should be installed so that the air is blowing into the case from the front. Note: We recommend NOT using the front fan for maximum quiet computing. If you choose to install a front fan, we recommend using Antec TriCool 120mm fan and set the speed to LOW. - Page 8 1. If you removed the tube under setting up, insert the notches on the tube into the tabs on the case and slide the tube towards the bottom of the case to secure it. 2. Slide the ACAG on to the Tube. 3.
- Page 9 To install the 80mm VGA fan: 1. Remove the two screws holding the silver metal stripe to the air inlet that connecting to the Tube of the ACAG. Set the parts aside. 2. Remove the two black screws holding the plastic panel to the ACAG. 3.
- Page 10 +31 (0) 10 462-2060 europe.techsupport@antec.com www.antec.com © Copyright 2005 Antec, Inc. All rights reserved. All trademarks are the property of their respective owners. Reproduction in whole or in part without written permission is prohibited. Printed in China. Version 1.0.1 4/25/2005...