Removing The Frame Side Screen Panels; Power Supply Installation - Antec SKELETON User Manual

3. Place the motherboard on the brass standoffs. Screw in the motherboard to the
standoffs with the provided Phillips-head screws.
Replace the Motherboard Tray onto the Component Tray, and the Component Tray
in the Frame as detailed in sections 2.1 and 2.2.
Note: You do NOT need to install an I/O panel for Skeleton. Your motherboard
should come with one. Keep it in a safe place. You will need it if you decide to
move your motherboard to a traditional case in future.

2.4 Removing the Frame Side Screen Panels

Removing the screens on either side of the Frame will allow access to the lower
level of the Component Tray for power and data cable routing.
1. Locate and simultaneously press inward the two tabs on the left and right sides
of the screen panel.
2. Pull the panel away from the Frame.

2.5 Power Supply Installation

1. Remove the power supply mounting plate from the rear of the Component Tray
by pulling upward on the metal tab and sliding the plate backward out of the tray.
2. Mount the power supply into the power supply mounting plate with the screws
provided.
5