Loading Paper Roll And Ribbon Cartridge - Sony UP-CR10L Operating Instructions Manual

Loading Paper Roll and Ribbon
Cartridge
Handling the paper roll and ribbon
cartridge
Notes
• The print pack contains two ribbon cartridges and two
paper rolls. Be sure to use the ribbon cartridge and paper
roll in the same carton as a set. (See "Ribbon Cartridge
and Paper" on page 61.)
• The number of sheets that can be printed depends on the
print pack type. The table below lists the image count for
one ribbon cartridge and paper roll set.
Print pack 2UPC-C13
Number of 300 (sheets)
sheets
Print size 89 × 126 mm
±2 mm
(3.5 × 5 inches
±3/32 inch)
• Do not replace the ribbon cartridge and paper roll before
they are used up. Otherwise the above number of sheets
may not be achieved.
• Place the paper roll vertically. If you place the paper roll
horizontally, the paper roll may roll around and fall. This
may cause an injury.
• Hold the paper roll with both hands so that you do not
drop it, because it is heavy. Dropping may result in an
injury.
Hold the paper roll with both hands.
12
Installation
2UPC-C14 2UPC-C15
200 (sheets) 172 (sheets)
101 × 152 mm 126 × 178 mm
±2 mm ±2 mm
(4 × 6 inches (5 × 7 inches
±3/32 inch) ±3/32 inch)
• An IC board is incorporated in the ribbon cartridge. Do
not touch the terminal of the IC board with anything,
including your fingers or metallic objects. Also, do not
strike, bend, or drop the IC board.
Attaching adaptors to paper holder
Paper roll widths vary according to the print pack. When
using the 2UPC-C14 print pack, attach an adaptor to the
paper holder to compensate for the width difference.
1
Open the front door.
2
Press the paper holder release button and pull the paper
holder out.
IC board