Operation; Loading An Ink Ribbon Cartridge - Sony UP-D2550S Service Manual

Digital color printer

Table of Contents

Connecting the Computer (continued)

Note

• SCSI cable connection requirement can vary between different computers and

peripherals. For the details of your installation, refer to the manual of your

computer and peripherals.

• Be sure not to connect the external terminator to the SCSI connector when the

terminator switch of the DIP switches is set to ON.

Turning on the power

You should turn on all peripheral devices before turning on your computers.

Particularly, make sure that all SCSI peripheral are turned on first.

Preparation

Operation

Before Printing

This section describes the following operations that must be made prior to starting

printing after mounting the paper tray and paper cover on the printer and making

the necessary connections.

• Loading an ink ribbon cartridge (see the below)

• Loading paper (see page 18)

Once the above operations have been completed, there should be no need to repeat

them during routine printing. Perform them only when absolutely necessary.

To make printouts, an ink ribbon cartridge and paper (which are compatible) must

be loaded. (see "Ink Ribbon Cartridge and Paper" page 22)

Use the ink ribbon cartridge and print paper (supplied) to check if the printer

functions properly.

Notes

• Use only ink ribbon cartridge and paper that are designed for use with this

printer. Failing to do so is likely to result in unsatisfactory printing or

malfunctions.

• When you replace the ink ribbon cartridge while you are operating the printer, do

not turn off the printer power. Turning off the power will cause the image stored

in the memory to be lost.

Open the front panel by pulling the front panel top toward you.

Continue to next page m

Operation

Table of Contents