Cleaning; Cleaning The Inside Of The Printer - Sony UP-CR10L Operating Instructions Manual

Cleaning

Cleaning the Inside of the Printer

If stripes, scratches, or other marks begin to appear on
prints, cleaning the inside of the printer may solve the
problem. Cleaning the inside of the printer is especially
effective in removing white stripes and scratches like those
shown in the figure.
White stripe
Speckled scratch
White stripes tend to appear when using the 2UPC-C13 or
2UPC-C15 printing pack after printing a large quantity of
prints with a 2UPC-C14 printing pack. Also, if foreign
particles become affixed to the thermal head, white stripes
or scratches may begin to appear. When this happens, use
the cleaning cartridge supplied with the printer and the
cleaning sheet supplied with the printing pack to clean the
inside of the printer.
The cleaning cartridge can be used repeatedly.
1
Bring up the administration screen on the UP-CR10L,
and select the System tab.
2
Open the side door, and remove the ribbon cartridge.
3
Insert the cleaning cartridge all the way into the
printer.
4
On the System tab, touch the
About 30 cm of print paper emerges, and a message
asking for confirmation to begin cleaning appears on
the screen.
58
Cleaning
5
6
Threadlike scratch
7
button.
Remove the paper from the back side of the cleaning
sheet (the side without an illustration).
Be careful not to confuse the back and front sides of
the cleaning sheet.
Determine by the width of the print paper the
orientation to affix the cleaning sheet, and affix the
cleaning sheet evenly and squarely onto the ejected
paper as illustrated.
When using the 2UPC-C14 printing pack, orient the
cleaning sheet lengthwise rather than crosswise.
Firmly affix the entire cleaning sheet so that the
corners do not peel up and the center is not raised. If
the corners of the cleaning sheet peel up, cleaning may
not be performed properly.
Remove the paper from the front side of the cleaning
sheet.