Installation; Connecting The Power Cord; Adjusting The Display Angle - Sony UP-CR10L Operating Instructions Manual

c ~ AC IN (Power Source) Connector (page 11)
Connect the supplied power cord here.
d Display stand
Use this stand to adjust the angle of the display.
e On/Standby button (for units with serial numbers
starting with 11 only)
Press this button to turn on power to the unit. Press it again
to enter the standby mode.
To restart the unit from standby mode, wait at least 5
seconds in standby mode, and then press the On/Standby
button.
f RS-232C interface
Serves for future expansion. Currently not used.
g Air vent
Features a built-in filter for the thermal head cooling fan.
h POWER switch (for units with serial numbers
starting with 51 only)
Turns the unit on or off.

Installation

Connecting the Power Cord

Connect the supplied power cord to the ~ AC IN connector
on the back of the unit, and then connect the plug to a
power outlet.
Power cord (supplied)

Adjusting the Display Angle

The display angle can be adjusted to make the display
more easily viewable. Eight settings are available for angle
adjustment.
When storing the unit, pull the display forward until
completely upright and then push it backward until
horizontal.
Power outlet
11
Installation