Table of Contents
Advertisement
Anti - Tip Device
A cabinet "anti–tip" device is mounted to the back of your refrig-
erated drawer unit. If your installation is a built – in under coun-
ter application with a counter-top directly above the unit this
item can be removed, it does not need to be applied. If your unit
is a freestanding application with no counter-top directly above
the top of the unit, you must apply this feature to prevent the
unit from tipping forward when the drawers are pulled out. The
anti–tip device is installed on the back of the unit. The anti–tip
device reduces the chance of personal injury as well as property
damage when properly installed between the back of the unit
and the adjacent wall. Please see the following instructions for
installing the anti-tip device.
1.
Push the unit against the wall so the anti-tip
bracket is flush to the wall adjacent to the back
panel. Level the unit with the leveling legs provided
in the cabinet bottom. (See Leveling Legs on
page 3).
2.
Using a pencil and the bracket as a template, trace
the bracket on the wall, making sure 2 of the screw
holes are aligned with a stud in the wall.
3.
Pull the unit away from the wall.
4.
Remove the screws that connect the upper and
lower sections of the anti-tip bracket.
5.
Place the bracket on the wall and mark and drill
3/16" diameter pilot holes for the provided ¼" lag
screws. Mount the lower section to the wall with the
¼" lag screws.
6.
Move the unit into place aligning the screw holes
between the upper and lower brackets and secure
with the screws removed in step 4.
Figure 3
Anti-Tip device
INSTALLING THE ANTI-TIP DEVICE
Remove these screws to separate
upper and lower sections of anti-tip
bracket.
To Refrigerated
Drawer Cabinet
To Wall
Figure 4
1/4" Lag screws
into wall
4
Advertisement
Table of Contents
