AGA marvel 6CRF Installation, Operation And Maintenance Instructions

AGA marvel 6CRF Installation, Operation And Maintenance Instructions

Advertisement

Installation
Operation
and
Maintenance
Instructions
Combination
Refrigerator / Freezer
6CRF
8CRF

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6CRF and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AGA marvel 6CRF

  • Page 1 Installation Operation Maintenance Instructions Combination Refrigerator / Freezer 6CRF 8CRF...
  • Page 2: Table Of Contents

    Words, and Labels. Door alignment ..............Dimensions for 6CRF solid door ........... Rough in opening dimensions for 6CRF solid door ..... Dimensions for 6CRF glass door ........... Rough in opening dimensions for 6CRF glass door....Dimensions for 8CRF solid door ...........
  • Page 3: Unpacking Your Refrigerator

    UNPACKING YOUR REFRIGERATOR Remove Packaging Warranty Registration Your refrigerator has been packed for shipment with all parts It is important you send in your warranty registration card im- that could be damaged by movement securely fastened. Cut mediately after taking delivery of your refrigerator or you can the banding material at the bottom of the carton, unfold the register online at www.agamarvel.com.
  • Page 4: Installing Your Refrigerator

    INSTALLING YOUR REFRIGERATOR Leveling Legs Select Location Adjustable legs at the front and rear corners of the unit should The proper location will ensure peak performance of your ap- be set so the unit is firmly positioned on the floor and level from pliance.
  • Page 5: Grounding Method

    GROUNDING METHOD AND ELECTRICAL REQUIREMENTS • Do not splash or spray water from a hose on the refrigera- tor! Doing so may cause an electrical shock, which may result in severe injury or death. • This unit should not, under any circumstances, be installed to an un-grounded electrical supply.
  • Page 6: Handle Installation

    HANDLE INSTALLATION AND DOOR ALIGNMENT PROCEDURE Handle Installation (Solid Door Models) Door Alignment Procedure 1. Remove the handle, (2) screws, and 5/32” hex key wrench The door should be parallel to the sides and top of the refrig- from the bag shipped inside the cabinet. erator.
  • Page 7: Dimensions For 6Crf Solid Door

    3” to 4” 22” (7.6 to 10.2cm) (55.9cm) ROUGH IN OPENING FOR 6CRF WITH SOLID DOOR Electrical Requirements: Electrical Requirements: A 115 volt, 15 amp dedicated circuit is required. A 3 prong grounded receptacle is required. Power outlet can be located in the back wall behind unit. Add 1”...
  • Page 8: Dimensions For 6Crf Glass Door

    3” to 4” 22” (7.6 to 10.2cm) (55.9cm) ROUGH IN OPENING FOR 6CRF WITH GLASS DOOR Electrical Requirements: Electrical Requirements: A 115 volt, 15 amp dedicated circuit is required. A 3 prong grounded receptacle is required. Power outlet can be located in the back wall behind unit. Add 1”...
  • Page 9: Dimensions For 8Crf Solid Door

    DIMENSIONS FOR 8CRF WITH SOLID DOOR 52-15/16” (134.47cm) 30-7/8” (78.44cm) 25-11/32” 29-7/8” (64.36cm) (75.9CM) 24-3/32” (61.19cm) 33-3/4” to 34-3/4” (85.7 to 88.3cm) 3” to 4” 22” (7.6 to 10.2cm) (55.9cm) ROUGH IN OPENING FOR 8CRF WITH SOLID DOOR Electrical Requirements: Electrical Requirements: A 115 volt, 15 amp dedicated circuit is required.
  • Page 10: Adjusting The Temperature Control

    ADJUSTING THE TEMPERATURE CONTROL Adjusting the temperature control After plugging in the units power cord set the temperature con- trol midway between the numbers. After 2 hours adjust to the temperature that suits you. The higher the number you select, the cooler the temperature.
  • Page 11: Energy Saving Tips

    ENERGY SAVING TIPS Energy Saving Tips The following suggestions will minimize the cost of operating your refrigeration appliance. 1. Do not install your appliance next to a hot appliance, (ovens, glassware washers, etc.). heating air duct, or other heat sources. 2.
  • Page 12: Care And Cleaning

    CARE AND CLEANING Cleaning instructions Condenser The condenser underneath the cabinet does not require fre- quent cleaning; however, satisfactory cooling depends on ad- equate ventilation over this heat exchanger. It is recommended to annually clean the condenser by vacuuming and brushing. To access the condenser, the unit must be pulled out from the installation, and the lower machine compartment access cover removed.
  • Page 13: Troubleshooting Your Refrigerator

    TROUBLESHOOTING YOUR REFRIGERATOR Before You Call for Service If the unit appears to be malfunctioning, read through this manual first. If the problem persists, check the troubleshooting guide below. Locate the problem in the guide and refer to the cause and its remedy before calling for service. The problem may be something very simple that can be solved without a service call.
  • Page 14: Obtaining Service

    If Service is Required: • If the product is within the first year warranty period please call AGA MARVEL Customer Service at 800.223.3900 for directions on how to obtain warranty coverage in your area. • If the product is outside the first year warranty period, AGA MARVEL Customer Service can provide recommendations of service centers in your area.
  • Page 15: Commercial Product Warranty

    AGA MARVEL shall issue a credit to the buyer The warranties set forth herein are the only warranties extend- for all or part of the purchase price, as AGA MARVEL shall de- ed by AGA MARVEL and are in lieu of all warranties, express, termine.
  • Page 16 www.agamarvel.com 1260 E. VanDeinse St. Greenville MI 48838 800.223.3900 41011887-EN Rev G 10/28/11 All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.

This manual is also suitable for:

8crf

Table of Contents