GE JP989 Owner's Manual & Installation Instructions page 11

Cleaningthe glass cooktop. CEAppliancescom
Cleanyourcooktopafter
each spill. Use CERAMA
BRYTE ® CeramicCooktop
Cleaner.
Normal Daily Use Cleaning
ONLY use CEIL_dMA BRYTE _'Ceranfic
Cooktop Cleaner on the glass cooktop.
Other creams ma_ not be as eflectixe.
To inaii_taii_ and protect the SUlti_ce _ff
your glass cooktop, t011ow these steps:
, l
[] Before using the cookto ) fi)r the
fi_t time, clean it with CEI_d'dA
BRYTE ') Ceralnic Cooktop Cleanei:
This helps protect the top and
inakes clean-up easiei:
[] Dail) tlse of CEl_z_d_/]_ BRYTE _:'
(2eramic ('xx)ktop Cleaner will help
kee I) the cooktop looking new.
[] Shake the clealfing cream well.
Appl_ a few drops of CEI_dMA
BRYTE e_Ceramic Cooktop Cleaner
directly to the cooktop.
[] Use a p_}per towel or CEIL&MA
BRYTE _"Cleaning Pad fi)r Ceran]ic
Cooktops to clean the entire
cooktop StlI'J[il c e.
[] Use a dry cloth or paper towel
to relnove all cleaning residue.
No need to rinse.
NOTE: It/a very important that you DO NOT
heat the cooktop until it has been cleaned
thorough/_
iii/ / / /L ¸¸
( 2
Usea CERAMA BRYTE *_Cleaning
Pad for Ceramic Co&tops or a
Scetch-Brite ® Multi-Purpose No
Scratch blue scrub pad.
Burned-On Residue
WARNING: DAMAGE to yourg/asssurface
may occurif youusescrubpadsother than
thepad bciuded with yourcooktop.
[] Allow the cooktop to cool.
[] Spread a few drops of CER,AAMA
BRYTE _> (]eralnic Cooktop (]leaner
to the entire burned residue area.
[]
Using the inchlded CEIL_MA
BRYTE _>Cleanin- Pad for Ceramic
Cooktops,
rub the residue
area,
ali))lxing, , pressure as needed.
[] If any residue renmins, repeat the
steps listed above as needed.
[] For additional protection, after all
residue has been relnoxed, polish
the entire surfi_ce with CERAMA
BRYTE ') (_eralnic Cooktop Cleaner
and a paper towel.
The CERAMA BRYTE '*_Ceramic
Co&top Scraper and aft
recommended supplies are
available through our Parts Center.
See instructions under "To Order
Parts" section
on next page.
NOTE:Do not use a duff or
nicked blade.
Heavy, Burned-On Residue
[] Allow the cooktop to cool.
[] Use a single-edge razor blade
scraper at approxinmtely a 45 °
angle against the glass surface and
scrape the soil. It will be necessary
to apply pressure to the razor
scraper in order to remove the
residue,
[]
After scraping with the razor
scraper, spread a few drops of
(%l_d'dA BRYTE <'_ Ceramic
()_oktop Cleaner to the entire
burned residue area. Use the
CERAMA BRYTE ') Cleaning Pad
to remove any renmilfing residue.
[] For additional protection, alter all
residue has been relnoxed, polish
the entire surtace with CERAMA
BRYTE ') Ceralnic Cooktop Cleaner
and a paper towel.
11