D-Link DSN-6120 User Manual page 118

ERROR SATA PRD mem fail
ERROR SATA revision id fail
ERROR SATA set reg fail
ERROR SATA init fail
ERROR SATA diag fail
ERROR Mode ID fail
ERROR SATA chip count
error
INFO SAS port reply error
INFO SAS unknown port
reply error
INFO FC port reply error
INFO FC unknown port
reply error
EMS events

Level
INFO Power install
ERROR Power absent
INFO Power restore
ERROR Power fail
WARNING Power detect
INFO Fan restore
ERROR Fan fail
INFO Fan install
ERROR Fan not present
ERROR Fan over speed
WARNING Thermal level 1
ERROR Thermal level 2
ERROR Thermal level 2
shutdown
ERROR Thermal level 2
CTR shutdown
WARNING Thermal ignore
value
WARNING Voltage level 1
ERROR Voltage level 2
ERROR Voltage level 2
shutdown
ERROR Voltage level 2 CTR
shutdown
INFO UPS OK
WARNING UPS fail
ERROR UPS AC loss
ERROR UPS power low
WARNING SMART T.E.C.
WARNING SMART fail
WARNING RedBoot failover
WARNING Watchdog
shutdown
WARNING Watchdog reset
Failed to init SATA PRD memory manager
Failed to get SATA revision id
Failed to set SATA register
Core failed to initialize the SATA adapter
SATA Adapter diagnostics failed
SATA Mode ID failed
SATA Chip count error
SAS HBA port <number> reply terminated abnormally
SAS frontend reply terminated abnormally
FC HBA port <number> reply terminated abnormally
FC frontend reply terminated abnormally
Type
Power(<string>) is installed
Power(<string>) is absent
Power(<string>) is restored to work.
Power(<string>) is not functioning
PSU signal detection(<string>)
Fan(<string>) is restored to work.
Fan(<string>) is not functioning
Fan(<string>) is installed
Fan(<string>) is not present
Fan(<string>) is over speed
System temperature(<string>) is higher.
System Overheated(<string>)!!!
System Overheated(<string>)!!! The system will auto-
shutdown immediately.
The controller will auto shutdown immediately, reason
[ Overheated(<string>) ].
Unable to update thermal value on <string>
System voltage(<string>) is higher/lower.
System voltages(<string>) failed!!!
System voltages(<string>) failed!!! The system will auto-
shutdown immediately.
The controller will auto shutdown immediately, reason
[ Voltage abnormal(<string>) ].
Successfully detect UPS
Failed to detect UPS
AC loss for system is detected
UPS Power Low!!! The system will auto-shutdown
immediately.
Disk <slot> S.M.A.R.T. Threshold Exceed Condition occurred
for attribute <string>
Disk <slot>: Failure to get S.M.A.R.T information
RedBoot failover event occurred
Watchdog timeout shutdown occurred
Watchdog timeout reset occurred
Description
118