Download Print this page

Advertisement

ISCSI IP SAN STORAGE
DSN-6000 Series
Quick Installation
Guide+
1

Advertisement

   Also See for D-Link DSN-610

   Summary of Contents for D-Link DSN-610

  • Page 1

    ISCSI IP SAN STORAGE DSN-6000 Series Quick Installation Guide+...

  • Page 2

    Quick Installation Guide DSN-6000 series iSCSI IP SAN storage Package Contents If any of the items are missing, please contact your reseller. IP SAN storage HDD trays Power cords RS-232 cables GBIC transceiver Rail kit Keys, screws for and cable for drives and rail kit DSN-6410/ 6420 only...

  • Page 3

    Install drives Note : Skip this section if you purchased a solution populated with drives. To install SAS or SATA drives with no Bridge Board use the front mounting holes: To install SATA drives with Bridge Board (DSN-654), fit the Bridge Board first. Then install the drive using the rear mounting holes: Drive slot numbering Slot 1...

  • Page 4

    4. To ensure MPIO is set-up automatically it is recommended that you log on the target twice (from controller 1 then controller 2). Note: iSNS server is recommended for dual controller system. DSN-6110: 1GbE to SAS/ SATA IP SAN storage, Single controller. DSN-6110 with DSN-610: 1GbE to SAS/ SATA IP SAN storage, Dual redundant controller.

  • Page 5

    DSN-6410: 10GbE to SAS/ SATA IP SAN storage, Single controller. DSN-6410 with DSN-640: 10GbE to SAS/ SATA IP SAN storage, Dual redundant controller.

  • Page 6

    Configuration 1.Web UI The D-Link DSN-6000 family includes a simple to use Graphical User Interface (GUI) for integration and management. Be sure to connect the LAN cable, open a browser and enter: http://192.168.0.32 A dialog box for authentication will pop up.

  • Page 7

    Step 3: “Next” Set up the data port IP and click Step 4: “Next” Set up the RAID level and volume size and click Step 4 Step 3 Step 5: Check all items, and click “Finish”. Step 5 Step 6: Done. 3.Logon Microsoft iSCSI initiator Here are the step by step instructions to setup Microsoft iSCSI Initiator.

  • Page 8

    Connect 1.Run Microsoft iSCSI Initiator. 2.Input IP address or DNS name of the target. And then click “Quick Connect”. 3.Click “Done”. 4.Your Computer can now connect to an iSCSI disk.

  • Page 9

    Notes...

  • Page 10

    Notes...

  • Page 11

    Notes...

  • Page 12

    Tech Support D-Link’s website contains the latest user documentation and software updates for D-Link products. U.S. and Canadian customers can contact D-Link Technical Support through our website or by phone. United States (877) 354-6555 http://support.dlink.com Canada (877) 354-6560 http://support.dlink.ca Ver. 1.00(US)

This manual also for:

Dsn-640, Dsn-6410, Dsn-6110

Comments to this Manuals

Symbols: 0
Latest comments: