Adding Paper And Toner; Loading Paper Into Paper Trays - Ricoh Aficio MP C3002 User Manual

9. Adding Paper and Toner

This chapter describes how to load paper into the paper tray and recommended paper sizes and types.

Loading Paper into Paper Trays

Every paper tray is loaded in the same way.
In the following example procedure, paper is loaded into tray 2.
• (mainly Europe and Asia)
Tray 1 can hold A4 paper only. If you want to print on A5 , B5 JIS , or 8
1, contact your service representative.
• (mainly North America)
1
Tray 1 can hold 8 /
1, contact your service representative.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• Check the paper edges are aligned at the right side.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
side fences are squeezed too tightly against the paper, the edges may crease, thin paper may
wrinkle, or the paper may be misfed.
1. Carefully pull out the paper tray until it stops.
2. Square the paper and load it print side up.
Do not stack paper over the limit mark.
× 11 paper only. If you want to print on A4 , A5 , or B5 JIS from tray
2
CJW011
1
/ × 11 from tray
2
135