Reversing Door Swing - GE Profile PCR06WATSS Owner's Manual And Installation Instructions

instatlation instructions
[] REVERSE DOOR SWING
SKIPTHISSTEPIF DOOR SWINGSUITSTHE INSTALLATION
Parts Included:
• Top left case hinge
• Bottom left case hinge
• Left and right side decorative hinge cover
• Decorative hinge screw hole cover
• Torx®driver bit
Tools Required:
• Phillipsscrewdriver
• Electricdrill
To remove the door:
• Flatten the shipping carton to use as a pad.
• Removethe 2 screws and the toekick. Set aside the screws
and toekick for final installation.
• Use the supplied Torx®bit and electric drill to remove
the 3 screws holding the top case hinge. Lift offthe hinge.
(Screwswill be used to install the new hinge.)
• Lift the door off the bottom case hinge,
• Remove the bottom case hinge pin and bracket,
To reinstall the door:
1. Remove the door stop and cam riser on the bottom right
side of the doon
2. Remove the bottom fill plug on the bottom left side of
the doon
3. Reinstallthe original door stop and cam riser onto the
bottom left side of the doon
4. Reinstallthe bottom fill plug on the bottom right side of
the doon
5. Remove the top fill plug on the top left side of the doon
6. Reinstallthe top fill plug on the top right side.
7. Install the new supplied bottom case hinge pin and
bracket onto bottom left side. Ensure plastic cam riser
is on the case hinge pin.
8. Placethe door onto the bottom case hinge.
9. Install the supplied left-hand top case hinge with the
3 original screws.
10. Select the hinge cover marked with an "L"
11. Peelbacking offthe tape insidethe decorative hinge cove_
12. Pressand snap the hinge cover into Install C overs
place. _b/
13. Snap the screw hole cover into
place on the opposite side.
IMPORTANT:Checkto be sure screws
are tight and that the door is straight
and does not sag, The door should swing freelu.
Install
3 Hinge_ !
Screws i
Remove
TopHinge
Hinge
Pinand
Bracket
Remove
Hinge
Install Toekick
The toekick has
a cutout on the
left and right
sides.
1. Remove the
plug on the
left side and
reinstall on
the right side.
2. Install
original
screws and
spacers.
Install screws through the spacer standoff, toekick and
into the base as shown.
11