GE Profile PCR06WATSS Owner's Manual And Installation Instructions page 9

Installation Instructions
THE INSTALLATION SPACE
The beverage center and wine chiller can be a free-standing
model or it can be built in using the cut-out dimensions
below.
Product dimensions:
Height 34-1/2" (876 ram)
Width: 23-3/4" (603 ram)
Depth: 25-1/2" {647 mm}
Cut-out dimensions:
Height: 34-1/2-35" (876-889 mm}
Width: 24" (610 mm} minimum
Depth: 24" (610 ram} minimum
25-1/2"
14__/23_3/4 ''/-'
34-1/2"
The cutout depth should be 24"
The cutout dimensions shown allow for a full door swing and
access to the pull-out racks when installed as a built-in in
standard 24" deep cabinets.
• The door should protrude 2-1/4" begond the surrounding
cabinets. For easy reference, the back edge of the pocket
handle should protrude a minimum of 5/8" beyond the
front edge of the countertop.
• If installing between frameless cabinets, a 1/2" wide
filler strip or side panel may be needed on hinge side.
The filler strip will act as a spacer between the case and
adjacent cabinet door swing. The width of the opening
must include the filler panels. NOTE:The door should
protrude 2-1/4" beyond the surrounding cabinets.
• The beverage center and wine chiller can be installed
freestanding.
Additionol Specificotions
• A 120 volt 60Hz., 15 or 20 amp power supplUis required.
An individual properlu grounded branch circuit or circuit
breaker is recommended. Install a properlu grounded
S-prong electrical receptacle recessedinto the back
wall as shown. Electrical must be located on rear wall
as shown. NOTE:GFI {ground fault interrupter} is not
recommended.
SIDE-BY-SIDE INSTALLATIONS
Increase storage capacit9 bg installing two beverage centers
or wine chillers together. Or,for a complete refreshment
center,install ang two of these units together.
• A side-bg-side installation requires at least a 47-1/2" wide
opening. No trim kits required.
• Productsmust operate from separate, properly grounded
receptacles.
9