Reversing The Door Swing - GE Monogram ZDWG240 Owner's Manual

To reverse
the door
Parts included:
1. Top left case hinge
2. Bottom left case hinge
3. Left and right side decorative
hinge cover
4. Decorative hinge screw hole cover
5. Torx ® driver bit
Tools required:
1. Phillips screwdriver
2. Electric drill
To remove the door:
1. Flatten the shipping carton to use as
a pad.
2. Remove the 2 screws and the toekick.
Set aside the screws and toekick for
final installation.
3. Use the supplied Torx
drill to remove the 3 screws holding
the top case hinge. Lift off the hinge.
(Screws will be used to install the new
hinge.)
4. Lift the door off the bottom case hinge.
5. Remove the bottom case hinge pin and
bracket.
Rotate the door:
The handle will be on the right side of
the door; hinges will be installed on the
left side of the case.
1. Remove the door stop and cam riser
on the original bottom right side of
the door.
2. Remove the fill plug on the top right
side of the door.
3. Turn the door over and reinstall the
fill plug on the new left side.
To reinstall the door:
1. Install the original door stop and
cam riser onto the bottom left side
of the door.
2. Install the new supplied bottom case
hinge pin and bracket onto bottom
left side.
® bit and electric

Reversing the Door Swing

Wine Chiller
Install
3 Hinge
Screws
Door Stop
and Cam Riser
3. Place the door onto the bottom case
hinge.
4. Install the supplied left-hand top case
hinge with the 3 original screws.
5. Select the hinge cover marked with
an "L".
6. Peel backing off the tape inside the
decorative hinge cover.
7. Press and snap the
hinge cover into
place.
8. Snap the screw hole
cover into place on
the opposite side.
IMPORTANT: Check to be sure screws are
tight and that the door is straight and does
not sag. The door should swing freely.
NOTE: See Installation Instructions to
apply hinge cover and screw hole cover.
Position nameplate:
Apply the Monogram nameplate on the
door using the template included in the
installation instructions.
Remove
Top Hinge
Hinge
Pin and
Bracket
Remove
Hinge
Install Covers
11