Table of Contents
Advertisement
To remove the door:
Reverse
• Remove the top hinge pin using a 1/8" allen
Door
wrench. Set aside.
• Lift the door off the bottom hinge.
Swing
• Re-install the top hinge pin.
• Remove the top hinge and re-install on the
bottom left side. Remove the bottom hinge
and re-install on the top left side.
• Insert the supplied plug buttons into the old
hinge holes, top and bottom.
The light trigger on the bottom of the door
must be removed and secured to the opposite
end.
• Remove the light trigger by backing out 2
screws. Set the trigger and screws aside.
• Install screws from plastic bag packed with
Use & Care Guide into light trigger holes.
• Turn the door upside down.
• Measure and mark 12-1/4" and 13" from the
right side (or 3/4" from the first location).
Measure and mark 11/16" from the front
side of the door. See illustration.
• Drill holes with 5/32" drill bit.
• Install the light trigger with original screws.
• Remove the top hinge pin using the 1/8"
allen wrench.
• Place the door onto the bottom hinge, and
install the top hinge pin with allen wrench.
• Open and close door to test door swing. If
door drags and does not close evenly, loosen
hinge screws and slip shims behind the
hinge. Tighten screws and test again.
Position new nameplate:
• Remove the original nameplate, now located
on the bottom of the door.
• Locate the template packed with the parts
package to position the new monogram
nameplate.
• Hold or tape template behind glass door.
• Remove backing from Monogram name-
plate.
• Place nameplate onto front side of door,
matching illustration on template.
Installation Preparation
Wine Chiller
Slip Shim
Behind Hinge
Light Trigger
Top of the Door
3/4"
11/16"
Front of the Door
Up pe r Le
ft
Co rne r
of
Gla ss
To p of
Na me Pla
te
To p of
Gla ss Do
or
DO OR
NA ME
PL AT E
LO CA TIO
N
Do or Fra
me Sid
e
P/N 41
00 52 63
Top Hinge
Bottom Hinge
12-1/4"
5
Advertisement
Table of Contents
