GE Profile PCR06WATSS Owner's Manual And Installation Instructions page 15

ge.com
Possible Causes What To Do
Moisture forms on Not unusual during periods • If bothersome, wipe surface dry; otherwise, moisture
outside of appliance of high humidity, will evaporate in time.
Door left open. • Always make sure that the door is closed after opening,
• Check to see if a bottle is holding door open.
Frost or moisture Too frequent or too long • Appliance will dissipate moisture in time.
collects inside door openings. If bothersome, wipe surface dry.
In humid weather, air carries • Appliance will dissipate moisture in time.
moisture into appliance when If bothersome, wipe surface dry.
door is opened.
Temperature control set at * See Temperature Control section.
coldest setting.
Interior light does Appliance is unplugged. • Push the plug completely into the outlet.
not operate The circuit breaker is tripped/ • Replace fuse or reset the breaker.
the fuse is blown.
Light bulb needs replacing. • See Care and Cleaning section.
GFI outlet is tripped. • Reset outlet.
• GFI outlet is not recommended.
Hot air from bottom Normal air flow cooling motor. * In the refrigeration process, it is normal for heat to be
ofappfience expelled in the area under the appliance. Some floor
coverings are sensitive and will discolor at these safe
and normal temperatures,
• This is normal. The appliance will cycle off after the
door remains closed for two hours.
• Normal operation in extreme temperatures,
Appfiance never shuts
off but temperatures
ore OK
Adaptive defrost keeps
compressor running during
door openings.
!5